Zanussi ZCG92496XA Panduan Pengguna - Halaman 20
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZCG92496XA. Zanussi ZCG92496XA 29 halaman.
Halaman Cetak
When the cleaning is completed, install the glass
panels and the oven door. To install the oven door,
do the above steps in the opposite sequence.
4
5
REPLACING THE LAMP
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate the appli-
ance.
You cannot activate or operate
the hob.
The oven does not heat up.
The oven / hob display shows
an error code that is not in this
table.
20
4
6
5
Possible cause
The appliance is not connec-
ted to an electrical supply or it
is connected incorrectly.
The fuse is blown.
There is an electrical fault.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and acti-
vate it again.
If the display shows the error
code again, contact the Cus-
tomer Care Department.
Remedy