Zanussi ZCG92496XA Panduan Pengguna - Halaman 25

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZCG92496XA. Zanussi ZCG92496XA 29 halaman.

ADJUSTING THE MINIMUM GAS LEVEL ON

THE HOB BURNER

1. Disconnect the appliance from the electricity.

2. Remove the knob for the hob. If there is no

access to the bypass screw dismount the

control panel before adjustment start.

3. With a thin and flat screwdriver adjust the

bypass screw A.

The model determines the position of the

bypass screw A.

Changing from natural gas to liquid gas

1. Fully tighten the bypass screw.

2. Put the knob back.

Changing from liquid gas to natural gas

1. Unscrew approximately one turn the bypass

screw position A.

2. Put the knob for the hob back.

3. Connect the appliance to the electricity.

WARNING! Put the mains plug

into the mains socket only if all

parts are back into their initial

position. There is a risk of injury.

4. Light the burner.

Refer to "Hob - Daily use" chapter.

5. Turn the knob for the hob to the minimum

position.

6. Remove the knob for the hob again.

7. Screw on slowly the bypass screw till the flame

becomes minimum and stable.

8. Put the knob for the hob back on.

LEVELLING

CAUTION! Remove all the

accessories from the oven.

1. Open the lid of the appliance and disassemble

it.

2. Disassemble the pan supports and all the

burner assemblies.

3. Put the appliance on the sidewall on a clean

and smooth surface. Place each foot into a

separate hole, in the plinth, and rotate it

clockwise.

4. If the floor is not equally flat, use the adjustable

feet on the bottom of the appliance to set a

stable position for the appliance.

To install all the accessories, do the first step in an

opposite sequence.