Zanussi ZKG5030 Panduan Pengguna - Halaman 32

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZKG5030. Zanussi ZKG5030 36 halaman. Range cookers
Juga untuk Zanussi ZKG5030: Fitur & Fungsi (9 halaman), Panduan Pengguna (36 halaman)

Zanussi ZKG5030 Panduan Pengguna
3. Check the supply pressure by turning the
Rapid burner on and one other hob burner
full on and light the appropriate burner.
The pressure should be either:
– For Natural Gas 20mbar
– For LP. Gas. The pressure must be set
to 29 mbar for use on butane or 37 mbar
for use on propane.
4. Turn off the taps, disconnect the pressure
gauge.
5. Check operation of each hob burner.

Checking the grill

• Place the grill pan containing the grid, with
the handle attached, into the grill compart-
ment. To light the grill burner push in and
hold the control knob, turn to the large flame
symbol (highest setting). Press the ignition
button immediately. Keep the control knob
depressed for up to 5 seconds, but no longer
than 10 seconds. After this time release the
controls. The flame should remain alight. If
after 10 seconds the burner has not lit, stop
operating the appliance and wait at least 1
minute before attempting a further ignition of
the burner. When the burner has lit release
the control and ignition button, adjust the
setting as required.
Checking the hob
• Lift the lid. Fit the burner crowns and caps
ensuring that they are correctly seated. Fit
the pan supports.
• To light the hob burner push in and hold the
control knob, turn to the large flame symbol
(highest setting). Press the ignition button
immediately. If the appliance is equipped
with, FSD you can also check the FSD sys-
tem by the following procedure: keep the
32
control knob depressed for up to 5 seconds,
but no longer than 10 seconds. After this time
release the controls. The flame should re-
main alight. If after 10 seconds the burner
has not lit, stop operating the appliance and
wait at least 1 minute before attempting a
further ignition of the burner. When the
burner has lit release the control and ignition
button, adjust the setting as required. Turn
off the hob and wait 1 minute. Turn the hob
control knob to the large flame symbol (high-
est setting). DO NOT depress or attempt to
ignite the burner. No gas should flow.

Checking the main oven

1. To light the main oven burner push in and
hold the control knob, turn to gas mark 9
Press the ignition button immediately.
Keep the control knob depressed for up to
5 seconds, but no longer than 10 seconds.
After this time release the controls. The
flame should remain alight. If after 10 sec-
onds the burner has not lit, stop operating
the appliance and wait at least 1 minute
before attempting a further ignition of the
burner. When the burner has lit release the
control and ignition button.
2. After 1 minute check that the flame covers
the full width of the burner and is stable.
3. Set the oven control to Mk 2, close the oven
door and check that after about 10 minutes
the flame size has reduced.
4. Turn off the control and check that the oven
flames go out.
Checking lid shut-off device
1. Lift the lid.
2. To light the hob burner push in and hold the
control knob, turn to the large flame symbol