Zanussi ZKG5540 Panduan Pengguna - Halaman 27

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZKG5540. Zanussi ZKG5540 44 halaman. Range cookers
Juga untuk Zanussi ZKG5540: Panduan Pengguna (44 halaman), Fitur & Fungsi (9 halaman)

Halaman Cetak

Care and cleaning

Before cleaning always allow the appliance

to cool down before switching off at the

electricity supply.

Cleaning materials

• Before using any cleaning materials on your

appliance, check that they are suitable and

that their use is recommended by the

manufacturer.

• Cleaners that contain bleach should not be

used as they may dull the surface finishes.

Harsh abrasives and scourers should also

be avoided.

Cleaning the outside of the

appliance

• Do not use abrasive cleaning materials e.g.

abrasive cream cleaners, wire wool pads or

scourers on painted or printed finishes as

damage may occur. Regularly wipe over the

control panel, control knobs, handles, doors

and appliance sides using a soft cloth and

hot soapy water. To prevent streaking, finish

with a soft cloth.

• Stainless Steel cream cleaners are abrasive

and should be avoided as they may dull the

surface finish. Any spillage on the

stainless steel finish must be wiped off

immediately.

Do not attempt to remove any of the control

knobs from the appliance as this may cause

damage and is a safety hazard.

Cleaning the hob

• Clean the hob using a mild abrasive.

• Take care not to damage the spark

electrodes. If the spark electrodes are

damaged the burners will not light. You can

remove the pan supports, burner caps and

burner crowns to clean them. Again take

care not to damage the spark electrodes.

• Clean the burner crowns and pan supports

by soaking them in very hot soapy water.

• Aluminium based saucepans can leave shiny

metal marks on the pan supports. You can

remove any stubborn stains by scouring with

a soap impregnated steel wool pad. If you

look after the burner crowns and pan

supports in this way they will stay reasonably

clean. However the surface will dull with

time. After cleaning the appliance parts, dry

them thoroughly before you put them back.

When replacing hob burner

parts

1. Crown to body. (Do not try to force the crown

on to the body). Make sure that the hole in

the crown is over the electrode. Check that

the location pegs sit in the slots in the body.

When the crown is in this position let it fall

freely on to the body. Check that the crown

can be moved slightly from side to side.

2. Cap to crown. Place cap centrally on the top

of crown (enamel side up). Move sideways

and front to back to check the cap is properly

fitted.

3. Check for ignition. If a burner will not light

then you need to check the crown and cap

positions.