Clarke MONZA Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Kompresor Udara Clarke MONZA. Clarke MONZA 8 halaman. Oil free 1.5hp
Juga untuk Clarke MONZA: Panduan Petunjuk Pengoperasian & Pemeliharaan (8 halaman)
Halaman Cetak
MONZA SPRAY UNIT
OPERATION
Before connecting your Monza to the mains supply, check that:-
(A) The Red coloured ON/OFF Rocker switch is in the 'O' position.
(B) The pressure regulator on top of the machine is in the low pressure or 'Start'
position i.e. turned fully anti-clockwise.
Connect the spraygun or the other tool which is to be used to the air outlet of the
Monza using the air hose which is fitted with quick fit adaptors at each end. An air
tight seal is formed by the rubber washer. Screw the connection together by hand,
just sufficiently for a proper seal to be made - but do not over tighten. If the face
of a rubber seal becomes damaged, then it may either be turned over or otherwise
replaced.
NOTE:
Please refer to the manual provided wityh the spraygun for its operation and
maintenance.
- 6 -
PAINT SPRAYING HINTS
PAINT THINNING
For a professional looking finish paint must be thinned. If manufacturers recom-
mendations on thinning are not available, the following can be used as a
general guide.
Water based paints (emulsions) 10-20% water.
Oil based paints (gloss) up to 10% thinners.
Cellulose paints up to 50 % cellulose thinners.
HANDLING THE GUN
the first requirement for a good resultant finish is the proper handling of the gun.
The gun should be perpendicular to the surface being covered and moved par-
allel with it. The stroke should be started before the trigger is pulled and likewise ,
released before the stroke is ended. This gives accurate control of the gun and
material.
The distance between the gun and the surface to be covered should be 6 to 12
inches depending on the material and atomising pressure. The material depos-
ited should always be even and wet. Lap each stroke over the preceding stroke
to obtain a uniform finish.
NOTE: To reduce overspray and obtain maximum efficiency, always spray with
the lowest possible atomising air pressure.
Cont.
- 11 -