Alecto DBX-77 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Monitor Bayi Alecto DBX-77. Alecto DBX-77 8 halaman.

TRANSMITTER

1. Place the transmitter about one meter away from the crib with the microphone

facing towards the baby.

2. Using the power/channel selector switch on the unit to either Channel 1 or 2.

The LCD will show the baby sleeping icon. If the batteries become run

down, the low battery icon will start blinking in the LCD. Recharge the battery

using the charger stand or operate from house current using the supplied

AC adapter.

3. Adjust the microphone sensitivity knob such that the unit will be set to transmit

whenever the microphone picks up a sound at your desirable loudness

level. The LCD will show the baby crying icons alternately once the unit is in

transmit mode.

4. The unit will automatically return to standby mode a few seconds after the

microphone stops picking up any sound.

5. Since this baby monitor is equipped with out-of-range alert feature, the

transmitter will transmit a signal to the receiver at regular intervals even when

the microphone does not pick up any sound. The out-of-range icon will blink

correspondingly in the LCD.

6. Everytime the unit transmits or gives a low battery warning, the LCD will be

back lighted automatically to show the icons in dark environment.

RECEIVER

1. Set the channel selector to the same channel as the transmitter.

2. Turn the volume control to switch on the unit at a reasonable distance away

from the transmitter. (Too close a distance will create feedback which cause

a queer sound at the speaker.)

3. The LCD will show the baby sleeping icon. If the batteries become run down,

the low battery icon will start blinking in the LCD. A low battery warning

alarm will also be heard. Recharge the battery using the charger stand.

N.B. The out-of-range alarm may also sound for a while until the unit

receives a signal from the transmitter.

OPERATION