Clarke Raider 100 Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Kompresor Udara Clarke Raider 100. Clarke Raider 100 17 halaman. 3hp direct drive compressor
Halaman Cetak
INSTALLATION
Warning: Before assembling and using the air compressor, make sure
that you have read and understood all of the safety instructions.
INSTALLATION
Take care when lifting the compressor from the packaging.
After removing the compressor from its packaging, check the integrity of the
unit, making sure it has not been damaged in transit.
Before connecting your compressor to the mains supply, check the following:-
• Firstly, ensure the compressor is on level ground. Do not allow it to
run if it is standing on an incline.
• Check that the mains voltage corresponds with that shown on the
data label on the compressor.
• The ON/OFF switch is in the OFF (pressed down) position.
MOVING THE AIR COMPRESSOR
Before moving the compressor, switch off and disconnect it from the mains
power supply.
• Always use the handle.
• Do not lift by (or put strain on) fittings, valves or hoses.
• Take care when moving the compressor to avoid damaging the
valves or fittings.
The compressor is heavy, get assistance when lifting or moving this compressor
to avoid personal injury.
FIT THE AIR FILTERS
1. Screw the air filter into postion as
shown.
• The air filters should be hand
tight, Do not over tighten.
5