Clarke RANGER 60 air Petunjuk Pengoperasian & Pemeliharaan - Halaman 6
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Kompresor Udara Clarke RANGER 60 air. Clarke RANGER 60 air 8 halaman.
Halaman Cetak
PREPARATION FOR USE
NOTE: All numbered items throughout this manual refer to the parts list item number
on Pages 12 - 15
1.
Remove the plastic travel plug from the oil filler hole,
on the top of the crank case, and insert the dipstick
(see Fig. 7 - page 9).
2.
Check the oil level is at the correct level on the
dipstick, as shown in Fig.1. Where necessary, top up
with Clarke international Compressor Oil (Available
from your local Clarke international superstore).
3.
Remove plastic travel plug from air filter inlet and
screw on air filter using the single screw provided.
OPERATION
(Ref. Fig. 2)
NOTE: If you intend using your compressor for spraying, read also the 'Helpful
Hints on Spraying" booklet - supplied with the machine.
1.
Check that the mains voltage corresponds with that shown on the data sticker
on the crankcase cover of the machine.
2.
Ensure that the ON/OFF switch is in the 'OFF' (0) position, i.e. pushed DOWN,
then plug in and switch on at the mains supply.
3.
To start the compressor pull UP the ON/OFF switch to the 'ON' (I) position
- the motor should start immediately.
Fig.1
Fig. 2
6
SPECIFICATIONS
Rotational Speed .................................................. 2850 rpm
Max. Pressure ........................................................ 10 bar
Air Displacement .................................................. 7 cu ft/min
Electric Motor ........................................................ 1½ hp (1.1kW)
Receiver ..................... Ranger 30 ....................... 24 Ltr
Ranger 60 ....................... 50 LTR
Cylinder Head Bolt Torque Setting ..................... 8.8Nm
Fuse Rating ............................................................ 13amps
Duty Cycle ............................................................ S1 at max. 7 bar
(i.e. Compressor may run continuously at 7 bar max.)
Please note that the details and specifications contained herein, are correct at the time of going to
print. However, CLARKE INTERNATIONAL reserve the right to change specifications at any time without
prior notice. Always consult the machines Data Plate
ACCESSORIES
Your Ranger Air Compressor can be used in conjunction with a range of optional
accessories for inflating tyres, air brushing, stapling, blowing and many other uses.
For details contact your local dealer.
A complete kit is available which is ideal for almost all applications (see below).
Please quote KIT400....part number 3110165
Also available without the spray Gun - Part No. 3110170
- or items sold separately
Should you experience any difficulties obtaining accessories, please contact
Clarke international by telephoning 01992 565300 for details of your nearest Clarke
international dealer
11