Clarke XET19/200 Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Kompresor Udara Clarke XET19/200. Clarke XET19/200 17 halaman. Electric motor driven
Juga untuk Clarke XET19/200: Panduan Petunjuk Pengoperasian & Pemeliharaan (17 halaman), Panduan Petunjuk Pengoperasian & Pemeliharaan (17 halaman)

BEFORE STARTING COMPRESSOR, CHECK:-

1. Compressor Pump Oil Level using (a) Dipstick (to level

marked) or (b) sight glass (see fig.1)

2. Automatic Control:- Pressure switch ON/OFF switch is in

the OFF position.

WARNING:

1. BEFORE STARTING COMPRESSOR, OPEN ALL OUTLET VALVES.

2. THE FOLLOWING START AND STOP INSTRUCTIONS MUST BE

FOLLOWED IN THE CORRECT SEQUENCE TO AVOID SERIOUS

DAMAGE TO THE COMPRESSOR/MOTOR.

1. Switch on isolator (mains supply)

2. Switch on pressure switch (lift knob or twist switch). (See "GENERAL

ARRANGEMENT" on page 8., item 22)

3. Check rotation (Flywheel/Fan blows air over pump)

4. Check that pressure does not exceed maximum working pressure

(stamped on machine plate), if the pressure exceeds the maximum

working pressure stated, stop the machine (see below), vent the system

and contact the Clarke Service Department.

1. Switch off at the pressure switch (Push knob down or turn switch).

2. Isolate from the Mains Supply.

3. Drain air receiver (release drain tap).

WARNING: COMPRESSOR PUMPS, DELIVERY PIPES WILL REMAIN HOT FOR

SOME TIME AFTER USE.

NOTE: When starting compressors up to and including the 3HP models,

an auto bleed valve will operate and air will be heard vent. This is

quite normal and should not cause concern. The valve should

close after several seconds. Should it fail to close, consult your

Clarke dealer.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]