Clarke ZX 500 Petunjuk Pengoperasian dan Pemeliharaan - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian dan Pemeliharaan untuk Kompresor Udara Clarke ZX 500. Clarke ZX 500 6 halaman.
Halaman Cetak
Safety Precautions
WARNING
As with all machinery, there are certain hazards involved with their operation and use.
Exercising respect and caution will considerably lessen the risk of personal injury.
However, if normal safety precautions are overlooked, or ignored, personal injury to the
operator, or damage to property may result.
It is in your own interest to read and pay attention to the following rules:
ALWAYS ensure that all individuals using the compressor have read and fully understand
the Operating Instructions supplied.
ALWAYS ensure that any equipment or tool used in conjunction with your compressor,
has a safety working pressure exceeding that of the machine.
ALWAYS adjust the pressure regulator to the recommended setting for the particular
tool being used.
ALWAYS protect yourself. Think carefully about any potential hazards which may be
created by using the air compressor and use the appropriate protection. ALWAYS use
Goggles when operating a nailer or similar tool. Face masks will protect you against
paint spray and/or fumes.
If spraying inflammable materials e.g. cellulose paint, ALWAYS ensure that there is
adequate ventilation and keep clear of any possible source of ignition.
ALWAYS make sure that children and animals are kept well away from the compressor
and any equipment attached to it.
. ALWAYS, before spraying any material always consult paint manufacturers instructions
for safety and usage.
ALWAYS, when disconnecting air hoses or other equipment from your compressor ensure
that air is shut off at the outlet and ALL pressurised air is expelled from the air line and
other equipment attached to it. (see 'Operation')
ALWAYS expel air from the receiver and disconnect from the mains supply BEFORE
carrying out any maintenance.
NEVER direct a jet of air at people or animals, and NEVER discharge compressed air
against the skin. COMPRESSED AIR CAN BE DANGEROUS,
NEVER adjust, or tamper with the safety valves. The maximum pressure is factory set,
and clearly marked on the machine.
NEVER leave pressure in the receiver overnight, or when transporting.
NEVER operate your compressor with any covers removed.
NEVER exert any strain on electrical cables and ensure that air hoses are not tangled
or wrapped around machinery etc.
NEVER operate in wet or damp conditions. Keep the machine dry at all times. Similarly,
a clean atmosphere will ensure efficient operation. Do not use in dusty or otherwise
dirty locations.
NEVER touch metal parts of the machine as these can become quite hot during
operation. Wait until the machine has cooled down.
!
Electrical or mechanical repairs should only be carried out by a qualified engineer. If
problems occur, contact your Clarke dealer.
- 4 -
Technical Data
Model ................................................................. ZX500
Maximum Air Pressure ....................................... 8 BAR - 116 PSI
Air Displacement ............................................... 5 CFM
Motor .................................................................. 1.25 HP
Voltage ............................................................... 230 VAC 50hZ 1pH
Motor Speed ...................................................... 2850RPM
Sound Power Level ............................................ 82dBL
Weight ................................................................ 20 kg (unpacked)
Part Number ....................................................... 3110278
Dimensions (mm) ............................................... 490x235x545mm
Duty Cycle .........................................................
**Duty Cycle...The motor on this machine may be run for 5
minutes only in any 10 minute period.
Please note that the details and specifications contained herein are correct at the time of going to
print. However CLARKE International reserve the right to change specifications at any time without
prior notice. Always consult the machines data plate
Accessories
A range of accessories, for inflating tyres, air brushing, stapling, blowing, paint
spraying etc., is available from your Clarke dealer.
NOTE:
If this compressor is supplied with an Air Nailer as part of KIT ZX500, then an 8
metre (25ft)Recoil Hose is also provided. Part No. 3110458
Parts & Service Contacts
For Spare Parts and Service, please contact your nearest dealer,
or CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or
e-mail as follows:
PARTS: [email protected]
SERVICE: [email protected]
WA
S3 50%**
- 9 -