Blackberry Radar H2 Panduan Instalasi - Halaman 29

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Radar Blackberry Radar H2. Blackberry Radar H2 30 halaman. Dry van, insulated trailers roll-up doors
Juga untuk Blackberry Radar H2: Panduan Instalasi (33 halaman), Panduan Instalasi (26 halaman), Panduan Instalasi (25 halaman), Panduan Instalasi (32 halaman), Panduan Instalasi (33 halaman), Panduan Instalasi (34 halaman), Panduan Instalasi (35 halaman), Buku Petunjuk (33 halaman), Panduan Instalasi (32 halaman), Panduan Instalasi (26 halaman), Panduan Instalasi (25 halaman), Panduan Instalasi (28 halaman)

3.4.5 Dry van/intermodal container installation procedure

If you wish to monitor door open/close events with your BlackBerry Radar-L module,

you will need to mount it on the door. Recommended module placement on dry van

and intermodal doors are as follows:

The unit should be installed as close to the center of the trailer/container as

•

possible. When installing on trailers or containers with door bars, ensure there is

approximately 1-2" (2.5-5cm) of clearance space between the left side of the unit

and the edge of the door bar.

The module should be placed as high on the door as possible for optimum antenna

•

performance. The placement height will be influenced, in part, by the height of the

ladder used for the install. At minimum, we recommend, the bottom of the module

is installed at least 80" (203cm)* above the interior floor of the container.

1. As indicated in Section 3.3 of this guide, record the module identifier and the asset

identifier the module will be paired with. For your convenience, you may quickly

create a record of the module and asset identifier pairings by removing the partially

attached label from the rear housing of the module and placing it on the installation

worksheet, next to the asset that will be tracked by this module.

BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE 29