Directed Xpresskit DBALL2 Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Dengan kunci Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 14 halaman. Ford5 remote start ready (rsr) installation
Juga untuk Directed Xpresskit DBALL2: Panduan Instalasi (12 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (18 halaman), Panduan Instalasi (13 halaman), Panduan Instalasi (14 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (15 halaman), Panduan Instalasi dan Referensi Cepat (16 halaman), Panduan Instalasi (18 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (18 halaman), Panduan Instalasi (16 halaman), Manual (19 halaman)

Halaman Cetak

Platform: DBALL/DBALL2

Firmware: FORD5 Range Extender Ready (RXT) Installation

SmartStart/XL202 Installation Notes

The DBALL Range Extender Ready (RXT) solution offers two (2) configuration options to control your system; RF Kit or

SmartStart (all sold separately). This section provides specific installation information for SmartStart and XL202.

SmartStart Revision A

SmartStart is optional and not included. It MUST be purchased separately.

Configuration Wires (White & Brown or Blue)

DBALL/

DBALL2

CABLE

D2D (4 pins, white)

The modules must be connected in a specific order. Refer to the Module Programming section for more information.

SmartStart Revision B

SmartStart is optional and not included. It MUST be purchased separately.

DBALL/

DBALL2

CABLE

D2D (4 pins, white)

The modules must be connected in a specific order. Refer to the Module Programming section for more information.

RF Kit

The optional XL202 and antenna are not included and MUST be purchased separately.

DBALL/

DBALL2

XOVER

1. Use the D2D Crossover (XOVER) cable that is provided with XL202, and NOT the one in the DBALL package.

2. The modules must be connected in a specific order. Refer to the Module Programming section for more information.

RF Kit & PKE Combination

Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information.

RF Kit, PKE & SmartStart BT Combination

Refer to the Passive Keyless Entry (PKE) Installation Guide (N2102T) for detailed wiring information.

Cut Brown or Blue Loop

4 pins

2 pins,

not used

Configuration Wires (Gray & White)

Connect Gray wire to (-) Ground

5 pins

4 pins

2 pins,

not used

LED

XL202

Prog.

Button

SmartStart

LED

THIS SIDE UP

Rev.: 20160317

Page 5