Clarke 07127A Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sander Clarke 07127A. Clarke 07127A 8 halaman. American b-2+ dc 7" edger
Juga untuk Clarke 07127A: Panduan Operator (20 halaman)

Halaman Cetak
Clarke 07127A Panduan Pengguna
Symptom
Sander will not
turn on
Excessive arcing
at motor brushes
Sander bounces
on floor when
sanding
Poor dust pick-up
Sander continues
to run in low speed
when switched to
high
Sander continues
to run in high
speed when
switched to low
56043143
Cause
No power at outlet
Defective cord or plug
Defective switch
Broken wire or bad connection
on brush holder assembly
Extremely worn motor brushes
Defective armature
Brushes worn
Broken wire or bad connection
on brush holder assembly
Worn or defective armature
Bent or damaged sanding pad
Dust bag is over 1/3 full
Dust bag is dirty
Obstruction in dust tube
Castors adjusted improperly
Two speed switch is defective
Two speed switch is defective
Diode is defective
Repair
Check and repair power supply or move to
another outlet
Check continuity and replace defective part
Replace switch
Repair or replace brush holder assembly
Replace brushes
Replace armature
Replace brushes
Repair or replace brush holder assembly
Replace armature
Dress or replace pad
Empty bag
Shake debris from bag and wash or replace bag
Clear dust tube
Adjust castors
Replace switch
Replace switch
Replace diode
Page 6