Clarke 6462011 Petunjuk Pengoperasian & Pemeliharaan - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Sander Clarke 6462011. Clarke 6462011 12 halaman. Random orbital sander
Halaman Cetak
16. ALWAYS have your power tool serviced by a qualified repair
person using only identical replacement parts. This will ensure
that the safety of the power tool is maintained.
17. NEVER operate machine while under the influence of drugs,
alcohol or any medication.
18. NEVER leave machine running unattended.
19. NEVER force the machine. It will do a better and safer job at
the rate for which it was designed.
20. NEVER use power tools in damp or wet locations or expose
them to rain.
21. NEVER operate power tools in explosive atmospheres, such as
in the presence of flammable liquids, gases or dust. Power
tools create sparks which may ignite the dust or fumes.
ADDITIONAL PRECAUTIONS FOR POWER TOOLS
1.
ALWAYS wear ear protectors/defenders as the noise level of this machine can
exceed 85dB (A).
2.
ALWAYS use the appropriate sanding sheet for the material being worked.
3.
ALWAYS keep the mains cable well away from the machine and ensure an adequate
electrical supply is close at hand so that the operation is not restricted by the length
of the cable.
4.
ALWAYS use extreme caution when using power tools, avoid contact with earthed or
grounded surfaces (e.g. pipes radiators etc).
5.
ALWAYS switch the machine OFF immediately the task is completed.
6.
ALWAYS use secure the workpiece using clamps or vice etc.
7.
ALWAYS store idle tools safely out of the reach of children in a dry location, preferably
locked away in a cupboard etc.
8.
NEVER allow the ventilation slots in the machine to become blocked.
9.
DO NOT exert pressure on sander to stop it quickly, allow it to stop normally.
10. DO NOT use the machine if the electric cable, plug or motor is in poor condition.
Additionally, please keep these instructions in a safe place for future reference.
Dust extraction
The sander is provided with a dust extraction facility, Please note however, that this does
not preclude the user from wearing a face mask to prevent the inhalation of dust
particles.
It is an EEC requirement that a dust extraction facility be provided on power tools, however,
due to the nature of the tool, some of the dust produced will be forced into the surrounding
atmosphere, and will not be collected.
4