Aleko Victoria Series Panduan Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Aleko Victoria Series. Aleko Victoria Series 17 halaman. Sizes 6.5x5 8x6.5 10x8
Juga untuk Aleko Victoria Series: Panduan Instalasi (20 halaman), Petunjuk Pemasangan dan Pengoperasian Manual (12 halaman), Panduan Perakitan (14 halaman)

Halaman Cetak

3. Insert the connector piece

it into place. Once inserted, screw it into place

4. At this time, the rectangle connector piece

with screws. A portion of the connector piece will stick out of the torsion bar until step 5.

5. Now, connect the second remaining torsion bar

place, just like in step 3.

6. At this time, you will have one full-length torsion bar, with both arm pieces connected and screwed securely into

place.

STEPS: Fabric Assembly

1. Open the fabric box carefully to ensure that the product is not damaged.

2. Unfold both pieces of awning fabric. You should have one large fabric piece

(0).

You should also have three fabric liner cords, two thick and one thinner

3. Thread the fabric liner, one thick and one thin, through both ends of the large awning fabric

process and is easiest with two people.

4. Once the liner is threaded through the large fabric, find the roller tube. Thread the fabric and its liner through the

slot/notch in the roller tube all the way to the end. Note: the fabric has a front and a back. The back side has a hem,

and should face downwards.

5. Now thread the other end of the awning fabric through the slot/notch in the front bar (wedge-shaped piece).

6. Once both sides of the large awning fabric are threaded, with one person on each side, pick up the roller tube.

7. Roll the awning fabric counterclockwise around the roller tube as tightly and evenly as possible.

8. Once fully rolled, place the roller tube back on the ground.

9. Finally, thread the valance

seen in the diagram.

(B-3)

into the interior end of the front bar

(B-B-1

(B-3)

will be connected to one of the two torsion bars

(B-1)

B-B-1

B-1

rr rr

�

N Thin Fabric (1 pc): will go on the roller.

through the other slot/notch in the wedge-shaped front bar all the way to the end, as

(0)

(B-2).

If insertion is difficult, use a mallet to tap

to the other side of the connector piece

B-B-1

B-3

J i

;

Steps 3, 4, 5

Step

(M)

(N).

N Thick Fabric (2pc) will go on the front bat

Steps 7, 2, 3

(B-2)

and secured

(B-3)

and screw it into

B-2

�

and a valence with a scalloped edge

This may be a slow

(M).