Clarke Contractor CON180 Petunjuk Pengoperasian & Pemeliharaan - Halaman 10
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Sander Clarke Contractor CON180. Clarke Contractor CON180 16 halaman.
Halaman Cetak
MAINTENANCE
WARNING: BEFORE COMMENCING ANY MAINTENANCE PROCEDURES,
ALWAYS ENSURE THE SANDER/POLISHER IS ISOLATED FROM THE
ELECTRICAL SUPPLY BY SWITCHING OFF AND REMOVING THE PLUG FROM
THE POWER SOCKET.
BEFORE USE
1. Always inspect the machine before use for any damage.
2. Ensure all fixing screws remain tight to ensure the tool is in safe working
condition.
3. Inspect the power cable to ensure it is free from cracks or bare wires etc.
CLEANING
1. Ensure all air ventilation slots are clear, (Use compressed air to clean the
tool if possible. Always wear protective goggles and a mask when
cleaning with compressed air).
2. Clean the exterior of the machine with a soft cleaning cloth. Never use any
chemicals or abrasives. Avoid using solvents when cleaning plastic parts,
which may be susceptible to damage from commercial solvents.
GENERAL MAINTENANCE
1. Occasionally inspect the motor
brushes and replace if necessary
after unscrewing the cover plate.
• When removing brushes, note
which way round they are. The
brushes must be returned
exactly as they are removed,
DO NOT swap over positions
etc.
2. A pair of long nosed electricians
pliers will be required to remove and replace the brushes. Pull the
connecting wire off the terminal. Lift up the retaining spring and carefully
rest the spring on one side of the brush holder while changing brushes.
• All bearings etc, in this tool are lubricated with sufficient high grade
lubricant for the machine lifetime under normal operating
conditions, therefore no further lubrication is necessary.
• Refer to your CLARKE dealer if internal maintenance is required.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10