Clarke METALWORKER 6500491 Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Sander Clarke METALWORKER 6500491. Clarke METALWORKER 6500491 13 halaman. 250mm buffer/polisher
ASSEMBLY
MOUNTING THE MACHINE
1. Bolt the buffer/polisher to a
workbench using the securing holes
shown.
• DO NOT block the ventilation
paths through the base.
• Check that the installation is
secure before turning the
buffer on.
FITTING BUFFING/POLISHING PADS
1. Place the spacer over the shaft.
2. Place the polishing mop between the washers and secure with the retaining
nut, hand tight.
• The shaft threaded ends are handed LH and RH.
3. Tighten the nuts enough to grip without crushing the buffing/polishing pad.
NOTE: Wheel rotation, when in use, will tighten the retaining nut.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
7