Aleko BSW07 Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Set Ayunan Aleko BSW07. Aleko BSW07 3 halaman. Nest swing

(x4)

M8 BOLT 53mm (X1)

(x4)

M6 BOLT 50mm (X8)

M8 BOLT 60mm (X4)

Step 1. Insert tapered end of Top Bar 1 into the end of Top Bar 2.

Make sure there is only 1 set of holes in the end connected to Top

Bar 1.

Use 1 F2 fastener to connect Top Bar 1 to Top Bar 2

**Always Make sure to place included washers between

fastener head or nut and adjoining swing components**

Step 2. Insert 1 Top Leg segment into either side of the T-shaped

Connector, secure with 2 F3 fasteners per Leg. Repeat for both

Connector and Top Leg assemblies.

Step 3. Insert either end of assembled Top Bar into Connecter and

Leg Assemblies. Use 2 F5 fasteners on each side to attach.

Step 4. Completely disassemble F1 U-Bolts then place u-shaped

bolt through the hole in the bearing assembly found at the end of the

Swing ropes.

Tighten open-ended F1 nut down onto u-shaped bolt, place 1 F1

washer on each end of the bolt and insert into Top Bar through 2

sets of vertical holes. Ensure washer placement between nuts and

Top Bar.

Place 1 F1 washer on the exposed threaded ends of the F1 bolt,

then attach F1 cap nuts and tighten down. Repeat for both sets of

Swing ropes.

Step 5. Insert 1 Bottom Leg into the open end of each of the 4 Top

Legs. Place a F4 fastener into each of the holes at the junction,

making sure the exposed threaded end is pointed away from the

Nest Swing.

Place Side Stay Bar over the exposed fastener ends so that the flat

side of the Stay Bar ends is in contact with the Top/Lower Leg

assembly.

Tighten F4 nut down onto Side Stay Bar.