Directed Electronics 1000HF Panduan Pemilik - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Alarm Mobil Directed Electronics 1000HF. Directed Electronics 1000HF 8 halaman. Python code hopping high frequency 6/96 change model 1000 owner's guide

Halaman Cetak

ONGRATULATIONS

on your purchase of a state-of-the-art vehicle security

system. This system has been designed to provide years of trouble-free operation.

Due to the complexity of this system, it must be installed by an authorized dealer

only. Installation of this product by any other person other than an authorized dealer

voids the warranty. All dealers are provided with a preprinted dealer certificate to

verify that they are authorized.

HE SYSTEM REQUIRES NO SPECIFIC MAINTENANCE

normal use. When the battery weakens, operating range will be reduced and the

LED on the remote will light dim.

card must be returned and the bar code serial number must

OUR

ARRANTY

not be removed. If the warranty card is not returned you don't have a warranty. It is

also necessary to keep your proof of purchase which reflects that the product was

installed by an authorized dealer. Make sure you receive the warranty card from

HIS OWNER

S GUIDE

should help you to get the most out of your system. Please

take the time to read it thoroughly, prior to using the system.

Your remote control is

your dealer.

Glossary of Terms

Control Unit The "brain" of your system. Usually hidden underneath the dash

area of the vehicle. It houses the microprocessor which monitors your vehicle

and controls all of the alarm's functions.

FailSafe

Starter Kill An automatic switch controlled by the security system

which prevents the vehicle's starter from cranking whenever the system is

armed. The vehicle is never prevented from cranking when the system is

disarmed, in valet mode, or should the starter kill switch itself fail. Your system

is ready for this feature, however installation of this feature may require

additional labor.

Input A physical connection to the system. An input can be provided by a

sensor, pinswitch or to existing systems in the vehicle, such as ignition or

courtesy lights.

LED Red light mounted somewhere in the vehicle. It is used to indicate the

status of your system. It is also used to report triggers and faults in the

system or sensors.

Shock Sensor This system is packaged with a Stinger™ DoubleGuard

sensor. This sensor is mounted in the vehicle and designed to pick up

impacts to the vehicle or glass.

Siren Noise generating device usually installed in the engine compartment of

the vehicle. It is responsible for generating the "chirps" you hear, as well as

the six tones you hear while the alarm is triggered.

Transmitter Hand-held, remote control which operates the various functions of

your system.

Trigger or triggered sequence This is what happens when the alarm "goes

off" or "trips." The triggered sequence of your system consists of 30 seconds

of siren sounding and parking light flashing.

Valet

Switch A small push button switch mounted somewhere inside the

vehicle. It is used to override the alarm when a transmitter is lost or damaged,

or to put it into Valet

Warn Away

response Lighter impacts to the vehicle will generate the Warn

Away

response. It consists of several seconds of siren chirps and parking

light flashes.

Zone A zone is a separate input that the alarm can recognize as unique. Each

input to the system is connected to a particular zone. Often two or more

inputs may share the same zone.

G438.696

95G438.PM5

mode.

shock

G438.696

95G438.PM5