Directed Electronics 410 Panduan Pemilik - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Alarm Mobil Directed Electronics 410. Directed Electronics 410 20 halaman. Dei automate 410: owners guide
Juga untuk Directed Electronics 410: Panduan Pemilik (20 halaman)

Halaman Cetak

1. Programming Options

To enter or exit Valet

Turn the ignition on and then off.

Press and release the Valet switch

within 10 seconds. The status LED

will light steady if you have entered

Valet Mode. To exit Valet Mode,

repeat the steps above. The LED will

turn off when exiting Valet Mode.

Panic Mode

If you are threatened in or near your vehicle, you can attract

attention by triggering the system with your transmitter! Just

press

and you will enter Panic Mode. The horn will honk and

the parking lights will flash for 30 seconds. To stop Panic Mode at

any time, press

NOTE: In order for Panic Mode to function, the vehicle's horn (or option-

al siren) as well as the vehicle's parking lights must be connected.

Rapid Resume Logic

The system will store its current state to non-volatile memory. If

power is lost and then reconnected the system will recall the

stored state from memory. If the unit is in Valet

battery is disconnected for any reason, such as servicing the car,

when it is reconnected the unit will still be in Valet Mode. This

applies to all states including arm, disarm, and Valet Mode.

1999 Directed Electronics, Inc.

Mode with the Valet switch:

, or

on the transmitter.

DRW-35

Mode and the