Alemite 8323-A Panduan Servis & Pengoperasian - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Servis & Pengoperasian untuk Pompa Air Alemite 8323-A. Alemite 8323-A 19 halaman. Ball valve air-operated double diaphragm pump
Recycling
Many components of Alemite
Metallic AODD pumps are made of
recyclable materials. We encourage
pump users to recycle worn out parts
and pumps whenever possible, after
any hazardous pumped fluids are
thoroughly lushed.
Alemite s1fmdl1sm-rev0211
IMPORTANT SAFETY
INFORMATION
IMPORTANT
Read these safety warnings
Read these safety warnings
and instructions in this
and instructions in this
manual completely, before
manual completely, before
installation and start-up
installation and start-up
of the pump. It is the responsibility of the
of the pump. It is the responsibility of the
purchaser to retain this manual for reference.
purchaser to retain this manual for reference.
Failure to comply with the recommendations
Failure to comply with the recommendations
stated in this manual will damage the pump,
stated in this manual will damage the pump,
and void factory warranty.
and void factory warranty.
CAUTION
Before pump operation,
i n s p e c t a l l g a s k e t e d
fasteners for looseness
caused by gasket creep. Re-
torque loose fasteners to
prevent leakage. Follow recommended torques
stated in this manual.
WARNING
B e f o r e m a i n t e n a n c e
or repair, shut off the
c o m p r e s s e d a i r l i n e ,
bleed the pressure, and
disconnect the air line from
the pump. The discharge
line may be pressurized and must be bled of
its pressure.
WARNING
In the event of diaphragm
rupture, pumped material
may enter the air end of the
pump, and be discharged
into the atmosphere. If
pumping a product which is hazardous or toxic,
the air exhaust must be piped to an appropriate
area for safe disposition.
WARNING
This pump is pressurized
internally with air pressure
during operation. Always
make certain that all bolting
is in good condition and
that all of the correct
bolting is reinstalled during assembly.
WARNING
When used for toxic or
aggressive luids, the pump
should always be lushed
clean prior to disassembly.
WARNING
B e f o r e
d o i n g
maintenance on the pump,
be certain all pressure is
completely vented from the
pump, suction, discharge,
p i p i n g , a n d a l l o t h e r
openings and connections. Be certain the air
supply is locked out or made non-operational,
so that it cannot be started while work is being
done on the pump. Be certain that approved
eye protection and protective clothing are worn
all times in the vicinity of the pump. Failure to
follow these recommendations may result in
serious injury or death.
WARNING
Airborne particles and
loud noise hazards.
Wear ear and eye
protection.
Models 8323 & 8323-A Page 8
a n y