Clarke CEB102 Petunjuk Pengoperasian & Pemeliharaan - Halaman 3
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Pompa Air Clarke CEB102. Clarke CEB102 4 halaman. Non-submersible water pump
Halaman Cetak
ACCESSORIES
1" Foot Valve Filter
1" BSP Spigot Hose Connector
1" I.D. Reinforced Hose for suction and delivery.
1" I.D. Layflat Hose for delivery only.
SPECIFICATIONS
TAM101
Motor
230V 50Hz 1ph
Power
0.5HP (370W)
Speed
2850 RPM
Max. Head
Max. Lift (Suction)
Bore Size
Max. Output
35 litres/min
Weight
Part Number
7320375
Please note that the details and specifications contained herein, are correct at the time of going to
print. However, CLARKE International reserve the right to change specifications at any time without prior
notice. Always consult the pump's data plate
When disposing of this product, do not dispose of with general waste. It must be disposed of according to the laws
governing Waste Electrical and Electronic equipment, at a recognised disposal facility.
PARTS & SERVICE
PARTS & SERVICE
Please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or
e-mail as follows:
PARTS: [email protected]
SERVICE: [email protected]
7950561
7950210
7955010
7955110
CEB102
230V 50Hz 1ph
0.5HP (370W)
2850 RPM
35M
35M
8M
8M
1"BSP
1"BSP
35 litres/min
5.8kg
6.25kg
7230325
6
ELECTRICAL CONNECTIONS
WARNING: THIS MACHINE MUST BE EARTHED.
I
nstallation should be carried out by a qualified electrician in accordance with
I.E.E. Regulations. However, in the further interests of safety we would emphasize
the following :-
This pump should be connected to a standard domestic 13 amp, 230 volt (50Hz),
electrical supply and we strongly recommend that the connection be made via
a Residual Current Device (RCD).
IMPORTANT: Should the supply be taken from a normal 13 amp socket, then the
plug used must be to BS 1363 standard, and the wires should be wired up in
accordance with the following colour code:
Green & Yellow .......... Earth or marked with a letter "E" or Earth symbol "
Blue ............................. Neutral or terminal marked with a letter "N"
Brown .......................... Live or terminal marked with a letter "L"
FUSE RATING
The fuse in the plug must be rated at 5 amps
T
he pump MUST be wired according to the diagram below, and ensuring the
following precautions are strictly observed:
WARNING:
DO NOT attempt electrical installation work if you are in any doubt as to how it
should be properly carried out. Consult a qualified electrician.
1.
The cable used must be of sufficient size
to ensure it is a tight fit in the cable gland.
2.
Ensure the cable gland is correctly used.
The clamp must firmly clamp the outer
cable sheath and NOT the conductors.
3.
Ensure the earth conductor is correctly
connected to the earth terminal.
The bare conductor should be wrapped
around the body of the screw, positioned
between the two washers, and the screw
suitably tightened.
3
".