Alemite 9911-A Panduan Servis - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Servis untuk Pompa Air Alemite 9911-A. Alemite 9911-A 4 halaman. High-pressure portable pump

Halaman Cetak

SER 9911-A

Assembly

NOTE: Refer to Figure 2 for component

identification on assembly procedures.

Hand Cart Assembly

1. Remove Bolt (26), Lock Washer (27) and Handle

Assembly (28) from Fork Assembly (23)

[as shipped].

2. Position the Handle Assembly on top of the Fork

Assembly.

3. Screw the Bolt with Lock Washer into the Handle

Assembly from the bottom of the Fork Assembly.

• Tighten the Bolt securely.

Follower Plate (Not Included)

4. Loosen Thumb Screws (10) that secure Cover

Assembly (9) to Container (12).

5. Remove the Cover and Pump Assembly from the

Container.

6. Install the 35-pound container into Spacer Ring (11).

NOTE: When bulk filling Container (12),

remove the Spacer Ring and fill the Con-

tainer with product. Do not allow air to mix

with the product during the filling process.

Pump may lose prime.

Revision (05-01)

7. Place the follower plate onto the top of the product.

8. Guide the pump tube into the follower plate and fit the

9. Secure the Cover to the Container with Thumb

10. Test/Prime the Pump assembly.

Accessories

Table 2.

Part Number

Table 2 High-Pressure Portable Pump Accessories

Changes Since Last Printing

Changed Handle from 305376-2 to 318414

High-Pressure Portable Pump

See Table 2.

• With a wobbling motion, eliminate any air that may

be trapped underneath the follower plate. Force the

product through the hole in the center of the plate.

Cover onto Container (12).

Screws (10).

• Refer to Service Guide SER 9911/9950 for details.

Accessory items available for these pumps are listed in

337665

Follower Plate (for 35-pound container)

338801

Follower Plate (for 70-pound container)

Description

Alemite Corporation