Directed Electronics Avital 4113 Panduan Pemilik - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Starter Jarak Jauh Directed Electronics Avital 4113. Directed Electronics Avital 4113 20 halaman. Directed electronics remote start owner's guide
Halaman Cetak
the ON position, the engine will shut down.
While the vehicle is running during remote start operation, the system
will monitor the vehicle and will automatically shut down the engine if
the system receives any of the following shut-down inputs:
•
The brake pedal is pressed.
•
The hood is opened.
•
The shutdown toggle switch is put into the ON position.
•
The pre-programmed run time has elapsed.
•
The single button is pressed and held for 3 seconds.
➢ Valet Take-Over
The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle for
short periods of time, but would like to leave the motor running
and the climate controls on.
To perform Valet Take-Over:
1.
Before turning off the engine, press and release the single button
once within 2 seconds.
2.
Turn the ignition key to the OFF position. (The engine will stay
running.)
3.
The engine will run until the pre-programmed time
elapses or a shut-down input is received. (See the
previous Remote Start section for a complete list
of shut-down inputs.)
Note:
This feature will not work if the brake pedal is
being pressed.
12
© 2008 Directed Electronics. All rights reserved.