Directed Electronics ProStart CT-3371 Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Starter Jarak Jauh Directed Electronics ProStart CT-3371. Directed Electronics ProStart CT-3371 12 halaman. 4-button automatic/manual transmission remote starter
Halaman Cetak
Driving Off
With the vehicle running under remote control, press the
installed) and unlock the doors. Enter the vehicle and do the following:
1.
Turn the ignition key to the
position while the engine is running. This would cause the starter motor to re-engage.)
2.
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Arming and disarming the starter kill
This added security feature will prevent the vehicle from starting with the Ignition key when the
starter kill is armed. If the system was installed with the starter kill option, you will not be able to
start the vehicle with the key unless the system has been unlocked first or put into Valet Mode
(page-7)
Note: If the Starter Kill is installed, the vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the CRANK position.
The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm
automatically) or Active Mode (so as to require the user's intervention for arming). By default, the
Remote Car Starter is configured to Passive Mode.
Passive mode:
•
To arm the Starter Kill, press the
•
In Passive Mode, the Starter Kill will also arm automatically 1 minute (by default) or 3
minutes (if configured this way) after the ignition is turned OFF or once the last door is
closed (if the doors are monitored).
-The LED on the antenna will remain OFF during the countdown preceding the
activation of the Starter Kill.
- Once the activation countdown expires, the LED will flash slowly to indicate that the
Starter Kill is now armed.
•
To disarm the Starter Kill, press the
- The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes (if
configured this way) if no door is left opened (if the doors are monitored) and the ignition
is not turned ON.
Active Mode:
•
To arm the Starter Kill, press the
- The parking lights will flash once.
- The LED on the antenna will flash slowly.
•
To disarm the Starter Kill, press the
- The parking lights will flash twice.
- The LED on the antenna will remain OFF.
User guide
position. (Do not turn the key to the
IGNITION ON (RUN)
button on the transmitter, OR
button on the transmitter.
button on the transmitter.
button on the transmitter.
button to disarm the starter kill (if
CRANK
P. 5