Directed Electronics ProStart CT-5472TW Panduan Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Starter Jarak Jauh Directed Electronics ProStart CT-5472TW. Directed Electronics ProStart CT-5472TW 19 halaman. Two-way 6-button lcd automatic/manual transmission remote starter system with full alarm system
Halaman Cetak
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle
has been running for 2 minutes already, pressing the
allow the engine to run for another cycle (in this case, 3 minutes).
Intrusion Codes via LED light
The system monitors the following:
•
Any vibrations sensed by the shock sensor such as someone breaking of the window,
windshield, etc.
•
Doors
•
Ignition
•
Trunk
•
Hood
Note: If an intrusion has occurred the siren will sound for a maximum of 1minute.
When an intrusion has occurred, pressing unlock will make the siren chirps four times. The
antenna's LED will provide an intrusion code corresponding to the type of the intrusion that
occurred. The LED intrusion codes are flashed in continuous loops.
2x = Doors intrusion
3x = Shock Sense
4x = Hood
Car Finder
When enabled, the Car Finder option will help you locate your vehicle by sending a pulsating signal
through the siren. The siren will chirp once each time the
Temporary Chirp Delete
To temporarily disable the chirp confirmations of the siren upon arming and disarming (e.g. in a
quiet neighbourhood):
• Press the
• Within 3 sec., press the
Missing a Start or a Stop Confirmation
If you have not received a Start or the Stop confirmation after pressing the
button within range of the remote starter's signal will refresh the display and will confirm if the
vehicle was started or stopped.
If no Start Confirmation Was Received:
•
Press the
If no Stop Confirmation Was Received:
•
Press the
User guide
button. The remote will beep once.
or
button:
The remote's
icon will start flashing
The
icon and runtime time countdown will be displayed.
button:
The
will be displayed
The remote's
icon and the runtime countdown will disappear.
button will reset the counter to zero and
5x = Panic
6x = Ignition
7x = Trunk
and
button to arm or disarm system without any chirp.
are pressed simultaneously.
button, pressing the
P.11