Directed Electronics PS-4661TWE-FM Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Starter Jarak Jauh Directed Electronics PS-4661TWE-FM. Directed Electronics PS-4661TWE-FM 19 halaman. Two-way fm led automatic/manual
transmission remote starter
Juga untuk Directed Electronics PS-4661TWE-FM: Panduan Pengguna (20 halaman)
Halaman Cetak
Driving Off
With the vehicle running remotely, press the
unlock the doors. Enter the vehicle and do the following:
1.
Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK
position while the engine is running. This would cause the starter motor to re-engage.)
2.
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Note: On some Push-To-Start (PTS) vehicles, no takeover is possible as pressing the brakes will
shut the engine down. Please talk to your technician to determine if the "Takeover mode" can be
set for your vehicle.
Remote Starter Features
Remote Door Locks
If your Remote Car Starter was installed with the Remote Door Locks option, you will have the
convenience of remote keyless entry.
To LOCK your doors and ARM the system:
1.
Press and hold the
2.
The remote will beep once to confirm locking of the doors.
To UNLOCK your doors and DISARM the system:
1.
Press and hold the
2.
The remote will beep twice to confirm unlocking of the doors.
Remote Trunk Release
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
button until the remote beeps once. In addition, this will also disarm the OEM-
style alarm (if installed).
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors locked
while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
Activating Idle mode (Automatic transmission):
1.
With the engine running, make sure to release the brake pedal and press the
or
button on the transmitter until the parking lights come ON.
Note: SmartStart™ can be setup to use the SmartStart™ icon to activate Idle mode.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle. All doors, the hood and trunk should be closed
4.
Press the
available). The engine will continue running.
a.
When re-entering the vehicle, the user must reinsert the key into the ignition and
turn it to the ON position (not Crank) without pressing on the brake.
User Guide
button for approx. 1 sec.
button for approx. 1 sec.
button to lock the doors, to arm the starter kill and to arm the alarm (if
button to disarm the starter kill (if installed) and
,
P.9