Clarke SUBMERSIBLE PUMP Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Pompa Air Clarke SUBMERSIBLE PUMP. Clarke SUBMERSIBLE PUMP 13 halaman. Gse series submersible pump

Clarke SUBMERSIBLE PUMP Panduan Petunjuk Pengoperasian & Pemeliharaan

Electrical Connections

230 Volt models:
Connect the mains lead to a standard 230 Volt (50Hz) electrical supply through an approved
BS1363, 13amp plug or a suitably fused isolator switch.
110 Volt models:
Connect the mains lead to a suitable 110 Volt (50Hz) electrical supply through an approved
plug or a suitably fused isolator switch. If using a portable 110 Volt transformer make sure it
has a rated capacity sufficient to take the load of the pump.
All models:
We recommend that this pump is connected to the mains supply through a Residual Current
Device (RCD).
WARNING! THIS APPLIANCE MUST BE EARTHED
I
MPORTANT: The wires in the mains lead are coloured in accordance with the following
code:
As the colours of the flexible cord of this appliance may not correspond with the coloured
markings identifying terminals in your plug proceed as follows:
Connect GREEN & YELLOW cord to terminal marked with a letter "E" or Earth
symbol "
" or coloured GREEN or GREEN & YELLOW.
Connect BROWN cord to terminal marked with a letter 'L' or coloured RED
Connect BLUE cord to terminal marked with a letter 'N' or coloured BLACK
230 Volt models:
If this appliance is fitted with a plug which is moulded onto the electric cable (i.e. non-
rewirable) please note:
1.
The plug must be thrown away if cut from the electric cable. There is a danger
of electric shock if it is subsequently inserted into a socket.
2.
Never use the plug without the fuse cover fitted.
3.
Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code).
4.
Replacement fuse covers can be obtained from your local dealer or most
electrical stockists.
5.
The fuse in the plug must be replaced with one of the same rating (13amps)
and this replacement must be ASTA approved to BS1362.
If you are in any doubt regarding electrical installation,
you should consult a qualified electrician
Green & Yellow
-
Earth
Blue
-
Neutral
Brown
-
Live
IMPORTANT:
-5-