Clarke Focus S28 Panduan Operator - Halaman 19
Jelajahi secara online atau unduh pdf Panduan Operator untuk Mesin Lantai Clarke Focus S28. Clarke Focus S28 20 halaman.
Halaman Cetak
HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Install The Brushes Or Pad Drivers
To install the brushes or pad drivers on the machine,
follow this procedure:
1. Turn the key switch "ON".
2. Put the brush switch in the "UP" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine.
5. Unlatch right and left brush housings and remove
them. See figure #9.
6. Put a brush or pad driver under the brush motor plate.
See figure #10.
7. Align the lugs on the motor gimbal with the slots in the
brush gimbal.
8. Pull the brush up until the gimbal locks.
9.
Repeat steps 6, 7, and 8 to install the second brush
or pad driver.
How To Remove The Brushes Or Pad Drivers
To remove the brushes or pad drivers from the machine,
follow this procedure:
1. Turn the key switch "ON".
2. Put the brush switch in the "UP" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine.
5. Push down on two sides of the brush or pad driver until
the gimbals release.
®
Clarke
Operator's Manual (EN) - FOCUS S28/L28/S33/L33/S38/L38 WB
ENGLISH
EN
Figure #9
Figure #10
- 19 -