LEGO 42031 Panduan Memulai Cepat - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Mainan LEGO 42031. LEGO 42031 8 halaman. Tow truck
Lay aside.
Bag 11. Make a part.
Put a F 3x3 corner piece on the table, ends to the left and to the front.
Insert a ridged stick upright into the cross-hole in the corner.
Insert another such stick into the left end cross-hole.
Put a F 5x1 oblong piece hor on top, its leftmost hole in the left stick, the middle hole in the right stick, and
overhanging to the right.
Lay momentarily aside.
Make a part. Put a F nut on a ridged nail stick, all the way to the head. Repeat. Put a 2x1 oblong piece on
the stick, with its round hole on and its cross-hole to the side.
Put a spiral on. Put a F nut on.
Turn this part ver, head to the back, and connect it to your main part by putting the cross-hole of the 2x1
oblong piece on the right stick of your main part.
Put a 3x1 oblong piece ver with its front cross-hole on the left stick.
Insert a ridged stick halfway into the back cross-hole of the same piece.
Put a F 5x1 oblong piece hor with its leftmost hole on the left stick, its middle hole on the right stick,
overhanging to the right.
Insert a ridged Philips stick a little way into the rightmost hole of the same piece.
Put a F 3x3 corner piece on top, symm to the similar piece at the bottom.
Insert a connector a little way into the front cross-hole of the same piece.
Repeat symm at the bottom.
Turn this part so that the ridged Philips stick is to the front at the left at the bottom and connect it to your
main structure, installing it from the top to the middle of your structure and by pushing the ridged Philips
stick all the way in.
lay momentarily aside.
Bag 13.
Put a 9x1 oblong piece hor on the table.
Insert a long connector from the front, short end first, into the second hole from the lefy.
Repeat at the rightmost hole.
Insert a connector from the front into the 5th hole from the right.
Install this part, as is. From the front, putting the leftmost connector of the main structure into the leftmost
hole of your part, the middle connector into the 4th hole from the left, and the ridged stick into the 6th hole