Clarke Devil IRD20B Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Pemanas Clarke Devil IRD20B. Clarke Devil IRD20B 17 halaman. Infrared diesel heater
Halaman Cetak
Any equipment or workshop furniture should be a safe distance away as they
could be adversely affected by heat.
VENTILATION
The heater must only be installed in a room which is well ventilated. Ventilation
is essential to reduce the dangers of carbon monoxide poisoning.
OPERATION
HEATER START UP
1. Plug the heater into the mains
power supply.
2. Set the power switch to the ON
position.
• The 'power-on' LED will
illuminate and the digital
temperature display will show
the room temperature for up to
3 minutes.
• Turn the temperature control
knob to adjust the target temperature required. This setting will be
shown by the digital display.
NOTE: If the heater does not start up, the temperature control may be set too
low. Turn the control knob to a higher setting until the heater starts. If
the heater does not start, switch the power switch off, then switch back
on again. If the heater still does not start, refer to fault-finding guide on
page 13. Also check that the power supply is correct.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11