Clarke 6500101 Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Peralatan Clarke 6500101. Clarke 6500101 12 halaman. Pipe notcher
Halaman Cetak
OPERATION
DRILL PRESS OPERATION
To use the notcher with a drill press, the notcher must be clamped securely to
the drill press base. It is important that the notcher is secure enough so it will
not twist or come off of the table during use. To ensure square cuts, the jig must
be square to the base before being mounted to the drill press table.
ITEMS NEEDED
• 1 x 13mm & 2 x 17mm Open End Spanners or Socket Wrenches
• 1 x Hole Saw with 1/2" or 5.8" Thread
• Drill Press with 14" Gap Between Chuck and Table
• Base Fastening Hardware, As Needed
• Cutting Fluid, As Needed
1. Install hole saw and workpiece as described on pages 7 - 8
2. Loosen both hex bolts on the angle joint
plate, then swivel the plate until square to
the frame, then tighten the hex bolts.
3. Place the notcher on the drill press
work table and adjust the table
until the top of the notcher spindle
is 1/2" lower than the drill chuck.
4. Loosen the two hex bolts from step 2 just enough so the notcher can be
aligned with the drill chuck.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8