Clarke IT1500 Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Peralatan Clarke IT1500. Clarke IT1500 17 halaman. Induction heater
Halaman Cetak
INSERTION PORT AND COIL SHOULD NOT BE TOUCHED BY HAND UNTIL
COMPLETELY COOLED DOWN.
USE OF THE TUBULAR HEATING COILS
• Function: The tubular heating coils (4,5 &
6 in the Overview on page 4) are used to
heat nuts, mechanical bolts, fasteners,
frozen door hinges, exhaust manifold
bolts, truck bed bolts, sensors (O2) etc.
NOTE: The service life of the tubular heating
coils can be prolonged by heating
the workpiece enough to disassemble without excessive heating.
During the heating process, the heating coils SHOULD NOT touch
the workpiece and heated object. If the temperature of the
workpiece is too high, the insulation layer of the coil may burn
out.
CAUTION: TO PROTECT THE FIBREGLASS INSULATION ON THE COILS DO NOT HEAT
UP THE WORK PIECE TO THE POINT IT IS GLOWING RED.
Loosening frozen, rusty, corroded screws and
nuts:
1. Follow the instructions for preparation of
operation and set up on page 8.
2. Press the heating switch to start the heater.
3. Place the related coil around the nut,
initially for two seconds only, pull it back
and try to remove the nut with a wrench or socket set. If it is still tight, apply
the coil for another two seconds and then try to unscrew again. Usually,
there is no reason to heat a screw/nut/bolt up to red hot condition in order
to remove the corrosion from the bolt.
USE OF THE U SHAPED HEATING COIL
• Function: The U shaped heating coil (2 in
the Overview on page 4) can perform
any work of the other coils and can be
customised to remove and repair dents.
10