Clarke METALWORKER CMSSCS Petunjuk Pengguna - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Peralatan Clarke METALWORKER CMSSCS. Clarke METALWORKER CMSSCS 8 halaman. Metal shrinker/stretcher set
Halaman CetakNOTE: Be careful not to lose any springs.
3. Lay out the die components as
shown in Fig 4.
4. Clean grease, metal shavings,
and debris off the tool and dies,
then lightly oil.
NOTE: Never use a wire wheel,
buffer, sand blaster, or
sandpaper on jaw teeth.
otherwise, tooth damage
may occur. It is better to let
the jaws soak in mineral spirits overnight, and then use a wire
brush or a fine dental pick to remove debris.
Figure 4 shows die and jaw assembly order.
5. Use Figures 4-5 as a guide to
arrange the die parts in the
correct order and reassemble.
6. The shrinker/stretchers are ready
for operation.
OPERATION
The Shrinker/Stretcher set is designed to create long, compound-curved metal
pieces out of a single strip of metal without multiple splice points.
Operation consists of inserting a
piece of metal in the tool and pulling
down on the lever to compress or
expand the metal at various points
along the length of the metal strip,
creating the bend or shape needed.
During the bending process, as you
work along the strip of metal, the
clamping pressure exerted by the
lever can be adjusted to create
curves with a nice smooth arch.
4