Clarke PKP411 Panduan Petunjuk Pengoperasian/Keselamatan - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian/Keselamatan untuk Peralatan Clarke PKP411. Clarke PKP411 8 halaman. Heating torch set
Halaman Cetak
ASSEMBLY
NOTE: A bottle of propane gas is required for use with this equipment, capable of
delivering a pressure of 4 bar. (A regulator is provided)
1. Turn the knob on the regulator fully clockwise, then attach the
regulator to the gas bottle, ensuring it is tight.
2. Attach the hose supplied, to the regulator at one end, and the torch at
the other, noting that the hose connections have LEFT HAND THREADS, i.e.
turn them anticlockwise.
3. Attach the appropriate nozzle/burner to the torch where necessary.
If a nozzle/burner is already attached, remove it carefully, complete with
adapter (see illustration below). Unscrew the nozzle from the adapter and
replace with that of the desired type or size. Screw the adapter with nozzle
back on to the torch.
Note:
1. Model PKP411 requires the torch extension to be attached to the torch.
OPERATION
With the hose and regulator attached, and ensuring the gas tap on the torch
is closed, i.e. turned fully clockwise, open the gas regulator valve.
Gas will now be available at the torch, the volume of which will depend
upon the regulator valve opening.
Very gently, open the gas valve on the torch, ensuring the nozzle/burner is
pointing well away from people or property, and apply a flame to the end of
the burner. Model PKP411 is equipped with a piezo electric starter on the
torch extension. Press the button until ignition occurs. Adjust the gas valve
until the desired flame is achieved.
Some models have a control lever attached to the torch. This is used to
further regulate the gas flow and hence the intensity of the flame. When the
lever is released the flame will reduce to a pilot light.
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
3