DirekTronik DVFX-110-TR Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pemanjang DirekTronik DVFX-110-TR. DirekTronik DVFX-110-TR 6 halaman. 1-fiber detachable dvi module

Halaman Cetak

Installation

Important: Please keep the installation procedure below. Improper or no

operation may result if the start-up sequence is not correctly followed.

Step 1

Carefully unpack the contents of the shipping group.

Step 2

Plug the 5V power adapters to the power jack of the transmitter and receiver.

Ensure the Power LED ON (Green) and Status LED blinking slowly (Green).

DVFX-110

Transmitter

Figure 2 – Connection of power adapter to the transmitter and receiver

Step 3

Please, check if the maximum resolution of the display is UXGA (1600x1200).

Otherwise, follow the instructions for Self-EDID Programming Procedure on

page 1-5.

Step 4

Connect SC optical fiber between the transmitter and the receiver as shown in

figure 3.

Figure 3 – Connection of optical fiber

Note: Both single and multi-mode fibers are applicable to DVFX-110-TR. The

maximum extension length by single mode fiber is 1,000meters and

500meters by multi-mode.

1-3 Installation

DVFX-110

Receiver

Step 5

Plug the transmitter to the DVI receptacle of the DVI source such as PC and the

receiver to the DVI receptacle of the display.

DVI Source

DVFX-110

Transmitter

Figure 4 – Connection of the transmitter to the DVI source and receiver to the display

Note: Be recommended NOT to use any intermediate cable or adapter between

them to avoid undesirable performance degradation.

Step 6

Make the PC and the display power ON. And ensure that the Status LED in

transmitter and receiver turn on.

By using an optical splitter OPS-xyz, one (1) signal from DVFX-110 transmitter

can be copied up to sixteen (16) times as shown in figure 5. For more

information, please refer to user's manual of OPSR-2, OPX-xyz.

DVFX-110

DVI Source

Figure 5 – Connection diagram using optical splitter, OPS-104S

Note: The maximum extension length can be shortened by using optical splitter

and additional fibers. The single-mode fiber is only applicable to OPS-xyz.

1-4 Installation

DVFX-110

Receiver

DVI Display

OPS-104S

Up to 1.5Km at WUXGA

DVFX-110

DVI Display 1

DVI Display 2

DVI Display 3

DVI Display 4