CLAS HU 1108 Manual - Halaman 10
Jelajahi secara online atau unduh pdf Manual untuk Peralatan Servis CLAS HU 1108. CLAS HU 1108 17 halaman. Mineral/multigrade oil electric clutch bleeder 5-20l 3.5bar
Halaman CetakMINERAL/MULTIGRADE OIL ELECTRIC CLUTCH
HU 1108
BLEEDER 5-20L 3.5bar
SPECIFICATIONS
(Subject to technical modifications, including equipment appearance)
Height: 860 mm
Width: 435 mm
Depth: 370 mm
Weight: 19.5 Kg
Capacity: 20 L
DFlow: approx. 40L/h (at 2.5 bar overall/2.0 bar pressure flow)
Hose length: approx. 3.5 mA
Power supply: AC 230V/50/60 Hz
Electrical power: 65 W
Fuse: M2.0A (5x20 mm)
Cable length: approx. 4.6m
Pressure range: 0-3.5 bar
Stop: Automatic at approx. 1 cm
Gauge: 0-6 bar (0-86 psi)
Working temperature: 0°C-45°C
INTRODUCTION
Note:
The HU 1108
electric filling and venting device represents the latest state of the art in the
maintenance of hydraulic systems, such as hydraulic circuits and clutch operations.
Suitable for hydraulic systems (e.g. hydraulic clutches) operating with mineral oil / hydraulic oil /
multigrade oil. The device has a very robust construction and can be used universally. Handling of
the unit is so simple that no special training of technicians is required. However, every technician
working with the unit must be trained in its use, and provided with operating instructions. By
using 20-liter containers of hydraulic oil, it is possible to carry out several fluid exchange processes
without having to refill them.
Important!
Contaminated hydraulic oil, containing air and water, can lead to hydraulic system failure. For this
reason, only use hydraulic oil from original containers. Change the hydraulic oil according to the
type and frequency specified by the hydraulic system manufacturer! When replacing hydraulic
oil in hydraulic systems, always use new hydraulic oil to flush out the old hydraulic fluid from the
system.