CLAS HU 1130BL Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Servis CLAS HU 1130BL. CLAS HU 1130BL 8 halaman. Brake bleeder and manual clutch 3l

HU 1130BL

BRAKE BLEEDER AND MANUAL CLUTCH 3L

SAFETY INSTRUCTIONS

• Keep this product in good working order and condition, take immediate action to repair or

replace damaged parts.

• Use approved parts only. Unapproved parts may be dangerous and will void the warranty.

• Keep children and unauthorised persons away from the work area.

• Keep work area clean and tidy and free from unrelated materials.

• Ensure the work area has adequate lighting.

• Do not use the kit to perform a task which it is not designed for.

• Do not allow untrained individuals to use the kit.

• Do not use the tool when you are tired or under the influence of drugs, alcohol or intoxicating

medication.

• Dispose of waste liquids in accordance with local authority regulations.

• Always read and comply with the warnings on the brake fluid container.

• Wear eye protection and avoid contact with the fluid. If brake fluid gets into your eyes, rinse with

plenty of water and seek medical advice. If swallowed, seek medical advice immediately.

• Warning! Only use new brake fluid. Used brake fluid or other fluids will contaminate the system and

possible brake system failure may occur.

• Warning! Do not discharge fluids in an uncontrolled way, by which the environment will be polluted.

• Warning! Brake fluid is flammable - keep it away from sources of ignition, including hot surfaces e.g.

exhaust manifold.

• Warning! Brake fluid will damage the paintwork. Any spillage should be flushed with water

immediately.

OPERATING INSTRUCTION

1. Make sure no pressure remains inside the unit. Pressure can be released from the release valve on

the side of the pump.

2. Remove the cap on top of the unit and fill the unit with new brake fluid. Make sure there is no

remaining old fluid or debris in the tank.

FILLING PROCEDURE

1. Select a suitable adaptor from the selection provided with the unit. Install the adaptor to the master

cylinder of the brake system.

2. Pump the handle of the unit up and down until the recommended bleeding pressure is reached.

Open the brake nipple and connect it to the suitable bleeding container. Once seeing the new fluid

coming into the container, close the nipple. Repeat the process on all 4 wheels (in any order).

3. When the brake fluid is flowing, ask a helper to pump the brake pedal while you watch the

fluid run through the clear tube. More than a few strokes may empty the master-cylinder reservoir, so

remember to keep checking it and top it up if necessary.

4. Once the process is complete, release the pressure by pressing down the release valve by the

side of the pump. After releasing, disconnect the fluid supply hose from the adaptor on the master

cylinder. Note: Do not disconnect the adaptor before releasing the pressure.

5. If necessary top up the brake fluid in the reservoir to the maximum level. Replace the master

cylinder cap on the vehicle.

6. Dispose the waste brake fluid in the bleeding container safely.