CTS CVT-3012SFP Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Konverter Media CTS CVT-3012SFP. CTS CVT-3012SFP 19 halaman. 10/100/1000base-t to 1000base-x (sfp slot)
standalone media converter
Juga untuk CTS CVT-3012SFP: Panduan Pengguna (2 halaman)
Halaman Cetak
available with a "copper" cable interface, allowing a host device designed primarily for
optical fiber communications to also communicate over unshielded twisted pair
networking cable.
SFP slot for 3.3V mini GBIC module supports hot swappable SFP fiber transceiver.
Before connect the other switches, workstation or Media Converter, make sure both
side of the SFP transfer are with the same media type, for example: 1000Base-SX to
1000Base-SX, 1000Bas-LX to 1000Base-LX and check that the fiber-optic cable type
matches the SFP transfer model. To connect to 1000Base-SX transceiver, use the
multi-mode fiber cable- with one side must be male duplex LC connector type. To
connect to 1000Base-LX transfer, use the single-mode fiber cable-with one side must
be male duplex LC connector type.
10/100/1000Base-T RJ-45 Auto-MDI/MDIX Port
1 x 10/100/1000Base-T RJ-45 Auto-MDI/MDIX ports are located at the front of the
Managed Converter. These RJ-45 ports allow users to connect their traditional
copper-based Ethernet/Fast Ethernet/Gigabit Ethernet devices to the network. All
these ports support auto-negotiation and MDI/MDIX auto-crossover, i.e. either
crossover or straight through CAT-5E UTP or STP cable may be used.
RJ-45 DB-9 Port
The RJ-45 DB-9 port is located on the front panel of the Managed Converter. This
RJ-45 DB-9 port is used for local, out-of-band management. This DB-9 port is DTE;
therefore, a null modem is required to connect the Managed Converter and the PC.
With a connection through RJ-45 DB-9 port, users can configure and check the
Managed Converter even when the network is down.
1.3 Management Option – Local Console Management
The Media Converter provides a console port for management and configuration. The
console port is located on the front panel of the Managed Converter. You can connect RS-
232 to RJ-45 cable from your PC to the Managed converter directly to access the Managed
Converter. The Managed Converter has the standard built-in menu-driven interface to
enable users to do the following:
Configure the system
Monitor the status
Reset the system
5