Aftershokz TREKZ TITANIUM Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Headphone Aftershokz TREKZ TITANIUM. Aftershokz TREKZ TITANIUM 5 halaman.

Halaman Cetak

Optional Accessories

FitBand (D)

Silicon rubber bands provide adjustability to accommodate smaller head sizes.

Slide FitBand (R) over the right transducer and along the right arm to rest over the charging port.

Slide FitBand (L) over the left transducer and along the left arm to align evenly with the right arm.

Rotate the FitBands around the arms until the desired fit is achieved.

Earplugs (E)

Use with headphones in environments where it is safe to block out ambient noise, such as on an

airplane or train.

Roll earplugs firmly between fingers and place in ears.

To adjust EQ settings to reduce or enhance bass while wearing earplugs, press and hold volume

up and down buttons simultaneously.

We're all ears! Got a question? Eager to share an experience?

Send us an email, or give us a call: [email protected]

To view this user guide in additional languages, visit bit.ly/TrekzUserGuide

+1-315-290-3855

Storage and maintenance

• Store the headphones in a cool and dry place. The working temperature should be 0~45°C(32~113°F). Working in cold/hot environments or highly humid

areas may reduce the life of the battery.

• After storing the headphones for an extended period, charge the unit before using it again.

• The headphones are sweat resistant, but are NOT waterproof. DO NOT submerge the headphones in water.

• Listening with headphones at a high volume may affect your hearing and may distort the audio.

• When cleaning the headphones, use a soft dry cloth.

• Do not charge your headphones immediately after exercising, as any sweat or moisture inside the charging port could lead to a circuit burning.

Note:

Design and specifications are subject to change without notice. For the most up-to-date product information, please visit www.aftershokz.com.

FCC caution

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.

Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Declaration of Conformity of Industry of Canada

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) This device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired operation of the device.

This Class (B) digital apparatus complies with Canadian ICES-003.