Nikon Coolpix 300 Panduan Memulai Cepat - Halaman 29

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kamera Digital Nikon Coolpix 300. Nikon Coolpix 300 32 halaman. Nikon coolpix 300: quick start

Halaman Cetak

1. Using the Coolpix 300

Alternatively, the camera may not be set up correctly. Check the setup

menus.

SETUP I/F

« SCSI »

ID [6]

TERMINATOR ON

SCSI setup

New to SCSI?

SCSI (Small Computer Systems Interface) is a method of connecting periph-

eral devices (such as scanners, digital cameras, and hard disks) to a computer

in a daisy chain topology

together, but one of these is always the SCSI controller. So that the controller

can distinguish between devices, each one must be set to a different ID

number, usually via a switch or software selection menu (as above). The

controller is usually set to ID 7, and if fitted, addresses 0 and 3 will normally

be assigned to a hard disk and CD-ROM drive, respectively. The first and

last devices in the chain always require termination. Termination (which may

be set by switches, by physically adding components, or, as above, through

software) ensures that the SCSI bus is in optimal condition and is essential for

reliable operation.

If you have installed a SCSI card in your computer, please enure that it (or

alternatively, any CD-ROM or hard disk that may be connected to it inside

your computer) is correctly terminated. It is always necessary to follow the

manufacturer's instructions to ensure successful installation. Note that SCSI

devices cannot be connected whilst the computer is powered on. Always turn

the computer off before connecting or disconnecting SCSI devices.

Nikon View : Establishing Communications with the Camera

1/2

OFF

DATA RATE

Serial port setup

. Up to eight devices can be connected

SETUP I/F

2/2

« SERIAL »

19200bps

9600bps