Nikon SMZ745T Petunjuk Manual - Halaman 13

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Mikroskop Nikon SMZ745T. Nikon SMZ745T 26 halaman. Stereoscopic zoom
Juga untuk Nikon SMZ745T: Petunjuk Manual (13 halaman)

Halaman Cetak

Adjust the diopter.

This adjustment is for adjusting the eyesight of the observer.

1 Turn the diopter rings on both eyepieces to set them at the 0 position

(match the 0 line with the index line).

2 Turn the zooming knob to 5X. Focus on the sample using the focus

knob. (Refer to "2. Focus on the sample." on p.10.)

3 Turn the zooming knob to 0.67X. Look into the left eyepiece with

the left eye, and focus on the sample using the diopter ring on the

left eyepiece. Then, look into the right eyepiece with your right eye

and focus on the sample using the diopter ring on the right eyepiece.

4 Repeat steps 2 and 3 until the image is kept focused even though the

zooming magnification is changed. This adjustment ensures the

sharp image throughout the zooming range.

This adjustment should be performed each time the observer is changed

since individual eyesights vary.

Change the zooming magnification.

The magnification of the sample image will change by turning the left and

right zooming knobs of the zooming body. Choose the desired

magnification.

■ Total magnification

The right zooming knob from the viewing side has the indication of the

zooming magnification. Total magnification can be calculated by

multiplying the eyepiece magnification by the zooming magnification.

Note) When the auxiliary objective is attached,

multiply its magnification as well.

■ ON/OFF of the zooming knob clicks

The clicks on the ON/OFF of the zooming

knob are available.

1 Remove the small rubber cap from the

rear of the zooming body.

2 Insert the supplied hexagonal wrench

(small) into the screw hole on the rear of

the zooming body.

Zooming

knob

OFF