Nikon COOLSHOT Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Ukur Nikon COOLSHOT. Nikon COOLSHOT 10 halaman.

Halaman Cetak

Changing Battery

• Type of battery: 3V CR2 lithium battery

• Battery condition indicators

: Battery has enough power for use.

: Battery is getting low.

flashing

: Battery is low and battery should be replaced.

disappears : Battery is exhausted and should be replaced.

* Flashing battery mark

on the LCD warns that the battery should be replaced.

1 Open the battery chamber cover

Using the ball of the thumb, etc. in the recessed part of the battery chamber cover, rotate the cover

following the Open/Close arrow indicator. It may not open easily due to its rubber packing for water

resistance.

2 Replace the old battery with a new one

Insert a new battery with the [+] and [-] correctly positioned following the "Battery installation"

indication seal in the battery chamber. [+] pole should be towards the inside of the chamber. If the

battery is not inserted correctly, the Nikon Laser Rangefinder will not operate.

3 Close the battery chamber cover

Align the Open/Close indicator with the white dot and insert the battery chamber cover. Using the ball

of the thumb, etc., turn the cover following the arrow indicator. It may not close easily due to the rubber

packing for water resistance, but continue to turn it all the way until it stops. Confirm that the cover is

securely closed.

• Battery life

Continuous operation: Approx. 2,000 times (at approx. 20°C)

Target focusing, measurement, and automatic power-off are included in a single cycle. This figure may differ

according to condition, temperature, and other factors such as target shape, color, etc.

* The Nikon Laser Rangefinder comes with a 3V CR2 lithium battery. However, due to natural electric discharge, the life of this

battery will likely be shorter than that noted above.

* Replace the battery if the Nikon Laser Rangefinder is ever submerged in water or if water enters the battery chamber.

Internal display

1. 『

』- Target mark/Laser irradiation

『

』- Aim at the target. Position the target at the center of the reticle.

『

』- Appears while the laser is being used for a measurement. (This laser

rangefinder does not feature a single measurement function.)

Warning: Do not look into the objective lenses when this mark is shown.

2．『

』 : Distance/measurement status display.

Digitally indicates measured distance in meters/yards. Also indicates measuring

status such as "Measurement in progress", "Measurement unsuccessful" or "Unable

to measure."

(Distance)

Display of results: ( ≧ 100m/yards)

e.g. 234 meters = 『

Display of results: ( ＜ 100m/yards)

e.g. 76.5 yards = 『

『』 - Now measuring

『

』 - Failure to measure or unable to measure distance.

3. 『

』Display Units:

『

』 Indicates distance being measured in meters.

『

』 Indicates distance being measured in yards.

4. 『

』 Indicates battery condition. (See "Changing Battery")

* Although the LCD is produced using the most advanced technology, it is impossible to eliminate dust

completely. An LCD usually displays at the same magnification or lower, however, the LCD of this unit is

highly magnified by the eyepiece lens. Because of this, when using this product, dust may appear as a defect.

This will not, however, affect measurement accuracy.

』