Nikon StabilEes 14x40 Buku Petunjuk - Halaman 11

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Teropong Nikon StabilEes 14x40. Nikon StabilEes 14x40 34 halaman.

Halaman Cetak

Keep Your Lenses Clean

Dust, salt and oil left from fingerprint smudges should never be allowed to remain on the lenses

because they can harm the coatings applied to lens surfaces.

Use lens cleaning tissues and lens cleaning fluid. Both are usually available wherever cameras,

binoculars or eye glasses are sold. For best results, when you need to clean one lens, clean all four.

Start by blowing off any dust that may be on the lenses. Then, follow these steps...

Use each tissue only once. Sometimes, it may be necessary to repeat the process.

Take a single lens tissue and fold it twice as shown.

Roll the tissue into a cylinder and moisten only one tip

with lens cleaning fluid.

Starting in the center of the lens, gently rub in a circular

motion from the center to the outside.

Specifications

Magnification........................14x

Compensation Angle

(Stabilization Freedom) ........±5°

Objective Lens Diameter ......40mm

Eye Relief ............................13mm

Apparent Field of View ........4°

Field of View at 1,000m........70m

Close Focusing Distance ....5m

Exit Pupil ..............................2.9mm

Brightness ............................8.4

Interpupillary Distance Adjustment

............................................60~70mm

Structure ..............................Waterproof (dry

nitrogen purged)

Waterproof models

The StabilEyes is waterproof, and will suffer no damage to the optical system if submerged or

dropped in water to a maximum depth of 1 meter for up to 5 minutes.

The StabilEyes offers the following advantages:

• Can be used in conditions of high humidity, dust and rain without risk of damage.

• Nitrogen-filled design makes it resistant to condensation and mold.

Observe the following when using the StabilEyes:

• As the unit does not have a perfectly sealed structure, it should not be operated nor held in running water.

• Any moisture should be wiped off before adjusting movable parts (focusing knob, eyepiece, etc.) of

the StabilEyes to prevent damage and for safety reasons.

To keep your StabilEyes in excellent condition, Nikon Vision recommends regular servicing by an

authorized dealer.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules and to EU EMC directive. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment

Regulations

Dimensions: L x W x D ........186 x 148 x 88mm

Weight ..................................1340g

(without batteries)

Battery Operating Life ..........6 hours

(continuous

operation with four

AA-type alkaline

batteries: at 20°C)

Safe Ambient Temperature Range

............................................-10°C to 50°C

(14°F to 122°F)

Due to ongoing product improvement,

specifications may be subject to change without

notice.