Dirt Devil CY08 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penyedot Debu Dirt Devil CY08. Dirt Devil CY08 16 halaman. Ultra lightweight compact cylinder

Halaman Cetak

MAINTAINING YOUR VACUUM

CLEANER

REMOVING THE HEPA POST-MOTOR FILTER

1. Press the air outlet grid knob to open.

CLEANING THE HEPA PRE-MOTOR AND POST-MOTOR

FILTERS

The filters in the vacuum cleaner will become dusty over time. This is normal and will not affect their

performance. However, if the filters become so dusty that suction power is reduced:

1. Remove the filters.

2. Rinse the filters under the tap.

3. Allow the filters to air dry for 24 hours. (Do not use

a heater, fire, hairdryer or other high-temperature

appliance to dry the filters.)

IMPORTANT

All filters should be checked regularly for signs of damage, preferably after each cleaning task. The

filters must be replaced immediately if they become damaged.

REMOVING OBSTRUCTIONS

The suction hole must be open and free of any obstructions at all times. Otherwise, the motor will overheat

and could become damaged.

IMPORTANT

Please note that there is a safety valve inside the vacuum to prevent the unit from being run with a high

vacuum rate. If the vacuum rate is too high, the safety valve will be turned on to protect the motor from

being broken.

PUSH

DOWN

2. Remove the HEPA post-motor filter to clean or change

it. Follow the cleaning instructions below to clean the filter.

4. Refit the filters into the vacuum.

This should be done once every six months or

when suction appears to be reduced.

USER MANUAL