Armorgard scrubkart SBK3T Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Konstruksi Armorgard scrubkart SBK3T. Armorgard scrubkart SBK3T 12 halaman.

Halaman Cetak

Safety information

• The ScrubKart is not WRAS approved and therefore should not be used for drinking water.

• All relevant PPE must be worn when using or setting up the ScrubKart.

• Take care with moving parts as they may present a finger trap hazard.

• A risk assessment must be carried out by a competent person before use.

• Some ScrubKart models include a boiler to produce hot water. The manual for the boiler must be read and

understood before using the ScrubKart. The manufacturers warnings and instructions are relevant and

should be understood before use.

• The hot water temperature is regulated by a thermostat which also acts as a resettable safety device to

prevent dangerous overheating.

• The boiler may need regular servicing on an annual or a usage-dependant basis. Owner must refer to the

separate manufacturers user manual.

• The ScrubKart's purpose is to maintain hygiene and sanitary standards on a site. To ensure it's continual

effectiveness, the ScrubKart and it's accessories must be washed and disinfected regularly.

• Relevant fire extinguishers must be nearby whilst the ScrubKart is in use.

• Regularly check visible cables, sockets and RCD for damage. If damaged, remove from service. Any

maintenance required should only be carried out by a competent person.

• The ScrubKart must be on level ground when in use or connected to power.

• The ScrubKart is a heavy product so care should be taken when manoeuvring or transporting it. Ensure the

containers inside are empty before moving it.

• The temperature on the water heater should be set and adjusted by a competent person.

• Care should be taken whilst emptying the waste water tank and it should be disposed of responsibly.

• Never mix the use of the water tanks. Waste water tank should only be used for waste water and clean

water for fresh water.

• Water should be checked regularly for Legionella and replaced if any trace found.

• Water heated to over 50° C can cause immediate serious burns if delivered directly to the taps, ensure the

water temperature is set to the correct temperature before use.

• Do not leave flammable materials in contact with or in the vicinity of the appliance.

• DO NOT use the appliance for any other than its specified use. The manufacturer is not liable for damage or

injury resulting from improper or incorrect use or failure to observe the instructions given in this manual.

• To reduce the risk from Legionella, long periods of water stagnations should be avoided; it means the system

should be used or flushed at least weekly.

• Before the ScrubKart is used for the first time, the water heater must be filled by pumping 15L of water

through the system.

• When draining the water heater, refer to the manufacturers guide for the correct procedure.

• In cold conditions or climates, ensure that the containers are left empty overnight.

Technical Specification

Product Code

SBK1T

Power Inlet

110V

Net Weight

100kg

Water Source

Tank

SBK2T

SBK3T

240V

N/A

100kg

95kg

Tank

SBK1M

SBK2M

110V

240V

100kg

External

SBK3M

N/A

95kg

External