Dirt Devil Swivel Glide Panduan Pemilik - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penyedot Debu Dirt Devil Swivel Glide. Dirt Devil Swivel Glide 9 halaman. Operating and servicing instructions
Juga untuk Dirt Devil Swivel Glide: Panduan Pemilik (9 halaman)
Halaman Cetak
%!#%?OR BRUSH REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS SCREWDRIVER
I
BELT STYLE:
4
&
5
1
WARNING: TO REDUCE THE RlSK OF INJURY FROM MOVING PARTS
-
UNPLUG CLEANER BEFORE CHANGING BEL T OR BRUSHROLL.
SUB-HEADING
TO REMOVE BELT
Flip cleaner to expose nozzle base as shown in
(Diagram 1). To remove nozzle cover, use Phillips screwdriver
to remove the four screws. Arrows in diagram 1 show location of screws. Flip cleaner back over and lift nozzle cover off. Slid
e belt off motor
sh ft (Diagram 2). Lift and remove brushroll (Diagram 3). Dispose of old belt.
cailouts
TO REPLACE BELT
1. Place belt on motor shaft, then slip brushroll through belt. Place belt in area of brushroll without bristles (Diagram 4).
2. With belt in place, pull and slide brushroll into n o d e (Diagram 3) making sure that the brushroll end caps are in the cor
rect orientation
(Diagram 3a inset).
IMPORTANT: Rotate brushroll manually in both directions to make sure belt is not twisted and is properly aligned.
3. Reattach nozzle cover. Secure by replacing the screws under the nozzle base.
BELT STORAGE
See page 4. (fig. 4)
-
stretch belt around hooks. (fig. 5)
-
fold and secure belt (in a u shape) on the inside of the loops on
the back of the
upright
LIGHTBULB* REMOVAL & REPLACEMENT
TOOL REQUIRED: FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RlSK OF ELECTRIC SHOCK
-
UNPLUG CLEANER BEFORE REMOVING OR REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For
bulb replacement call 1-800-321-1 134 or your local auto parts store.
1. Remove front panel (See page 9, Diagram 1). Lean cleaner handle back. Insert end of standard screwdriver into the side slot a
nd Ply
outward to pop headlight lens out.
2. Pull bulb out of socket to remove. Push bulb into socket to replace (Diagram 2).
3. Snap headlight lens panel back into place. Reattach front panel.
HOW TO TRANSPORT CLEANER
Use the carrying handle on the back of the cleaner to move cleaner from room to room (Diagram 3).
NOTE: Do not push cleaner forward while leaning on back casters, pull cleaner on back casters, or attempt to l i i ? cleaner using upper handle.
*
Not available on all models