CLOG MAINTENANCE
TOOL REQUIRED: PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE CLEANING CLOG.
NOTE: First check brushroll for clog, if clog persists, then check lower hose.
2.
1.
Locate lower hose/clog clean-out
Remove one (1) screw and pull
(see "FEATURES", number 15 for
lower hose down and away from
location).
cleaner. Remove obstruction.
TROUBLESHOOTING GUIDE
WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG CLEANER BEFORE SERVICING
PROBLEM
POSSIBLE REASON
Cleaner won't run
1. Power cord not firmly plugged into
outlet.
2. Blown fuse or tripped breaker.
3. Needs service.
4. Thermal Protector activated.
Cleaner won't
1. Dirt container not installed correctly.
pick-up or low
2. Dirt container full.
suction
3. Brushroll worn.
4. Broken or worn belt.
5. Clogged filter.
6. Nozzle/brushroll clogged.
7. Hose clogged.
Dust escaping
1. Dirt container full.
from cleaner
2. Dirt container not installed correctly.
3. Hose not installed correctly.
4. Filter not installed completely.
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE (1-800-321-1134)
In the event that further assistance is required, see your Yellow Pages for an authorized Royal
our website at www.dirtdevil.com. Costs of any transportation to and from any place of repair are to be paid by the
owner. The service parts used in this unit are easily replaced and readily available from an authorized Royal
or retailer. Always identify your cleaner by the model number and manufacturing code when requesting information or
ordering replacement parts. (The model number appears on the bottom of the cleaner.)
3.
Replace lower hose and
replace one (1) screw.
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace
fuse/reset breaker.
3. Take to service center or call 1-800-321-1134.
4. Unplug cleaner - allow to cool.
1. Review dirt container removal & replacement -
Pg. 7.
2. Empty dirt container.
3. Replace brushroll.
4. Replace belt.
5. Remove filter and clean.
6. Check nozzle/brushroll; remove obstruction/clog.
7. Remove hose; remove clog.
1. Empty dirt container.
2. Review dirt container removal & replacement.
3. Review hose installation.
4. Review filter removal & replacement.
®
Dealer or visit
9
Dealer
®