Armstrong 3033S Panduan Instalasi dan Pemeliharaan - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pemeliharaan untuk Unit Kontrol Armstrong 3033S. Armstrong 3033S 20 halaman. Water temperature controls groups of fixtures - thermostatic

Halaman Cetak

Installation

General

Installation must be carried out in accordance with these instructions, and must be conducted by designated,

qualified and competent personnel.

The installation must comply with all relevant local and state water plumbing codes.

All plumbing components are to be supplied by the installer. Failure to include these components will compromise

the product, system performance and will void the warranty.

Notes:

1. Model 320 is supplied fully performance and pressure tested.

2. Suitable connections for ease of maintenance should be used on the inlet and outlet ports. (Isolation valves

and unions.)

3. The hot and cold water inlet supply pressures must be nominally equal.

4. The inlet supply pipework must be thoroughly flushed before fitting the Model 320 valve.

5. The Model 320 can be installed in both rising supplies and falling supplies.

Installation Requirements

The use of supply strainers will reduce debris entering the Model 320. The recommended gauge for such

strainers is 35 mesh (mesh aperture dimension = 0.5mm).

Inlet pressure tappings which allow measurement of the inlet pressures to the Model 320 under operating

conditions are particularly recommended for in-service testing.

Pipework must be rigidly supported to avoid any strain on the connections.

Inlet and outlet threaded joint connections should be made with PTFE thread sealing tape or liquid sealant.

Do not use oil-based, non-setting joint compounds.

Run water for 1 minute from both hot and cold supplies to eliminate pipe debris. It is essential that supply

pipes are thoroughly flushed through before connection to the Model 320.

Tools Required

Driling

Drill Bit

Machine

size 6 mm

Screw Driver

Pencil

Plus & Minus

Adjustable

Allen Keys

Spanner

3mm & 2.5mm

Safety

Glasses