Blacoh SPILLSTOP Panduan Instalasi dan Pengoperasian - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Produk Pipa Blacoh SPILLSTOP. Blacoh SPILLSTOP 8 halaman. Leak containment system
Juga untuk Blacoh SPILLSTOP: Panduan Instalasi dan Pengoperasian (12 halaman)
Halaman Cetak
MODEL Specifications & Installation Information
Model No.
Body Material / Lid
Purchased From
Copyright © 2015 BLACOH Fluid Controls, Inc. All rights reserved.
Information in this document is subject to change without notice. No part of this publication may be reproduced, stored in a retrieval system
or transmitted in any form or by any means electronic or mechanical, including photocopying and recording for any purpose other than the
purchaser's personal use without the express written permission of BLACOH Fluid Controls, Inc.
Safety Warnings
Read and observe all instructions and safety symbols in this Manual before installation, operation or maintenance.
The following symbols indicate cautions, warnings and notes that must be observed for safe and satisfactory installation,
operation and maintenance.
WARNINGS
CAUTIONS
NOTES
General Safety
ATEX models must be grounded (earthed) before operation.
Always wear safety glasses and other appropriate safety equipment when installing or repairing SPILLSTOP.
Temperature limit is determined by the liquid inside the SPILLSTOP and materials of construction. SPILLSTOP has
no moving parts to generate heat.
Static spark can cause an explosion resulting in severe injury or death. Ground SPILLSTOP and pumping
system when pumping flammable fluids or operating in flammable environments.
ATEX Standard
Certain models made for the European market comply with the ATEX standard for use in potentially explosive
atmospheres. These models have the AT designation at the end of the part number and comply with EC standard
EN-13463-5 with protection degree of II 2GD T4XA.
EC standard EN-13463-1 and EN-13463-5 (ATEX) require grounding (earthing) on units when the potential for static
sparking is present. A grounding point is located and marked on ATEX specific SPILLSTOP models.
1
TM
Serial No.
Float Material
Contact
Danger of serious injury or death could occur if these warnings are ignored.
Equipment damage, injury or death could occur if these cautions are not observed.
Special instructions for safe and satisfactory installation, operation and maintenance.
BLACOH Fluid Control
Installation Date
Pump Area and Number
Phone
Email